Dimensions and static properties of Aluminum Channels are indicated below. For full table with Static Parameters Moment of Inertia and Section Modulus - rotate the screen! Some results are removed in response to a notice of local law requirement. For more information, please see here.
DIMENSIONS FOR HOT ROLLED STEEL BEAM, COLUMN, CHANNEL AND ANGLE SECTIONS ( Third Revision ) 1 SCOPE This standard covers the nominal dimensions, mass and sectional properties of hot rolled sloping flange beam and column sections, sloping and parallel flange channel sections and equal and unequal leg angle sections. 2 REFERENCES Some results are removed in response to a notice of local law requirement. For more information, please see here.
Channel Equipment cord = Connection Patch cord/ jumper CP cable work area cord Permanent link CP link FD CP TO EQP C C C C TE C Figure 3 Channel and permanent link diagram The performance specifications are separated into six classes (C to F) for balanced cabling. This allows for the successful transmission of applications over a channel.
FOR STRUCTURAL STEEL: ANGLES, CHANNELS, PLATES, STEEL RODS, FLAT PROFILES AND STRIPS 10 12. Add requirements for ISO in para.2. Specification was overwriting according a new format. 13. Removed the demand that number of pieces per bundle package is to be equal and in multiples of 10 units (for light profiles) and 5 units (for heavy profiles , q690f distributor
Section D Web t Flange T Root Radius r1 Ratios for Local Buckling Second Moment of Areas mm mm mm mm mm cm4 cm4 Thickness CHANNELS To BS4: Part 1 Width of Section B Toe Radius r2 Depth Between Fillets d Flange b/T Web d/t Axis x-x Axis y-y mm mm Serial Size 432 x 102 65.54 431.8 101.6 12.2 16.8 15.2 4.8 362.4 6.05 29.7 21400 629 Some results are removed in response to a notice of local law requirement. For more information, please see here.
66 SUPERSTRUT METAL FRAMING Engineering data and specifications Design data metal framing channel Table 1 Elements of sections properties for design Nominal thickness (inches) 12 ga = 0.105 14 ga = 0.075 16 ga = 0.060 Single channels Double channels Legend I Moment of inertia S Section Modulus r Radius of Gyration Z Nominal Axis A , q690f distributor
RIVA ACCIAIO Catalogue - Updated - November, 2013 Page 5 of 20 Hot Rolled Round Steel Bars Quality Conditions SURFACE DEFECTS Defects are allowed up to a depth 0,8 % of the diameter or of the section side, with min. 0,3 mm and max 0,6 mm conforming with the following standards:
Note: Section tables are not numbered and put in the list, except from High-Tensile Galvanised C and Z Purlins, Mild Steel Plates, Chequered Plates, API 5L (1991) and ASTM A53 (1997) pipes, Steel Sheet Piles to EN 10248:1996 and Other Steel Sheet Piles.